• Wood
• Plastic
• Other low temperature substrates
  

Coil-O-Rod or COR Generators
These elements deliver fast start-up in only three minutes and are available in 500, 750, 1000, 1500, 2000 and 3000 watts. Ideally suited for:

• Powder coating
• Baked enamels
• Moisture dry off
• Vacuum Forming
• Degreasing
• Softening plastics for compression molding

These heaters are 90% heat transfer efficient by producing medium wave infrared as well as convection heat. 

Both ceramic or COR elements have a 12” square aluminum reflector located behind the element to accurately direct the radiant heat towards the product, in a uniform pattern, providing an effective target zone.  Aluminum is second only to gold in its ability to reflect the radiant heat towards the product. If the reflector is clean and efficient, you can touch the reflector even after the oven has been on for hours. Reflectors need to be cleaned if reflector is hot to the touch.
 

Ceramic Panel Heaters
These heaters are used for heating large, massive or reflective products. Panel heaters are also a great option when space is limited. Watt densities up to 25 watts per square inch can efficiently transfer heat at high rates as well as shorten oven cycles. In large products, the coatings may be cured without heating the entire mass of the part. This means the cooling time is shortened as well.

Ceramic Panel Heaters create a great deal of convection heat along with radiant energy. Complex parts, hidden areas, and reflective materials are heated in a similar process of a convection oven, but with the speed of radiant heat.

Series FS Heaters
The Series FS heaters are high watt density, up to 45 watts per inch square, that offer on/off response times of about 30 seconds. FS heaters use a serpentine metallic element. They are appropriate for high temperature applications with more delicate substrates that would be damaged if the production line should stop. Temperature is controlled with a K thermocouple and a set point temperature controller. With proper oven design, a moderate amount of convection heat can be retained, maximizing both radiant and convection heat. A protective stainless steel face screen keeps any product off of the face of this powerful heater. 

V Series Heater
The V-Series is utilized in applications that require high power, tight process control, and fast heat-up/ cool-down. V-Series have fast on/off time which is excellent for web and textile applications.  V-Series heaters have similar response time to short wavelength infrared but are more durable.